The Benefits Of Our Antifoul Solution

Clear hull more speed

Your hull will remain clear of growth and therefore allow you to maintain your maximum speed. It will also help to keep clear all those underwater areas that are critical to the performance of your boat.. ie speed log impellors, water intakes for engine and aircon units, props and running gear.

Save fuel

The fuel savings will be substantial, particularly for motor boats. Pushing a heavily fouled hull through the water takes considerably more power than a clean one which has much less resistance. It can take up to 20% more fuel to push a dirty hull through the water. An Ultrasonic antifoul system will pay for itself!

Once only installation

You will only install this once... and you won't get covered in paint when you do it! So you can look forward to more time on the water and less time in refit and annual maintenance. The antifoul system pay for itself in a very short time if you consider the cost of the lift in and out of the water, the cost of the antifoul and the cost of the person to apply the same. Even if it is you that does it, your time could be spent more pleasurably.

Environmentally friendly Antifoul solutions

You'll be doing your bit as there are no pollutants associated with this method of preventative antifouling. It is also completely harmless to humans and animals.

It makes an awful lot of sense! View the Ultrasonic Antifouling Testimonials

Installation is simple

There are no holes to be drilled in the hull, Ultra 10 or Ultra 20 is bonded to the inside of the hull, using a pre threaded fixing ring, the transducer is simply screwed into the ring and the cable run to the control box, which is attached by 4 screws to any bulkhead... connect to power source ( mains or DC) ... and Enjoy the benefits!

How do I choose which Ultra I need?

There are two sizes available, the Ultra 10 which is suitable for boats with a waterline length of up to 10 metres. This is supplied with one transducer and is suitable for both sail and power boats.
The Ultra 20 is suitable for boats with a waterline length of up to 20 metres and comes with two transducers, which should be sited equidistantly along the centreline of the hull within reason. This unit is also highly suitable for catamarans.

The main consideration is the waterline length when choosing the correct model for your boat. The siting of the transducers is very straightforward as they are fixed to a convenient place on the inside of the boat's hull.
All units are available in either DC (12-32 volts) or AC (100-240 volts) and now the Smart switching Dual voltage system.

Other considerations for power boats - click here.